Whirlpool WFW5720RU Front-Load Washer Troubleshooting & Support

Using this guideMatch the full model number and regional manual before following a procedure. Instructions for a related model might differ.

Quick model summary

Appliance model

Whirlpool Front load washer WFW5720RU

Error-code evidence

No model-specific codes verified in this database

First step

Record the exact display message and complete model suffix before using a troubleshooting guide.

Official resources

Manufacturer support

This page covers the Whirlpool WFW5720RU Front-load washer for the United States. It explains the confirmed product features, safe first checks and official support routes. A full error-code list and diagnostic procedure have not been verified for this exact model and revision.

Whirlpool 4.5 cu. ft. Smart Front Load Washer, Volcano Black WFW5720RU Error Codes

No manufacturer-confirmed error symbols are currently recorded for this exact model. This does not prove that the appliance cannot display a code or warning.

No verified code list available. Use the matching model manual or manufacturer support for unexplained display messages.

The directory currently provides no verified error-code table for this model. Check the official model manual and symptom advice; do not apply generic codes from another appliance.

The Volcano Black model includes FreshFlow™ features that help manage moisture after washing. Whirlpool also lists 4.5 cu. ft. capacity and app connectivity, subject to Wi-Fi and Remote Enable requirements. Whirlpool product listing confirms the stated product details.

Safety first

Stop using the washer for smoke, sparks, a burning smell, damaged wiring or water near electrical components; disconnect electrical power only when it is safe. Do not remove service covers, probe wiring, or open drain components without the correct model instructions.

Quick help

What you seeSafe next stepWhen to request service
Unknown code or warningCopy the characters exactly, note whether they flash, and check the complete model and serial label. Match the display using Whirlpool’s model-specific literature, not only the general table below.Request help if the message persists or the appliance is not operating normally.
Washer will not fillConfirm that household supply valves are on and visually inspect accessible inlet hoses for kinks; do not disconnect a hose while pressurized.The washer repeatedly fails to fill, or a leak is present.
Water remains after a washCheck the visible drain-hose route for a kink without moving or opening the machine. Pump-filter access requires the matching manual.Water remains, or drainage repeatedly stops.

Error codes and display messages

Evidence status: No exact-model Whirlpool US manual or verified fault-code table was obtained for WFW5720RU. This does not prove a code is inapplicable. The examples below are unconfirmed for this model and must not be used as model-specific diagnoses.

General Whirlpool reference examples

These Whirlpool US help articles apply to broad appliance categories; none confirms the listed code appears on this exact model or engineering revision.

Display / code exampleMeaning in general Whirlpool guidanceSource and applicability
F8 E1 / LO FLWhirlpool's general front-load guidance describes low or insufficient fill.Whirlpool general guidance
Not confirmed for WFW5720RU
F9 E1The general front-load guide identifies a long-drain problem.Whirlpool general guidance
Not confirmed for WFW5720RU
F5 E2The general guide describes a washer-door locking problem.Whirlpool general guidance
Not confirmed for WFW5720RU

Do not assume that different spellings separated by a slash appear on the same machine. The official category guidance is a reference for asking Whirlpool about an actual display, not an instruction to run a reset or open panels.

Common problems

What you notice: Residual moisture after a wash or an unfamiliar cycle notification.

What to check: The listed FanFresh® and Dry Drum functions address post-cycle freshness; use the Whirlpool control instructions before interpreting an on-screen notice as a malfunction.

When to stop: Stop if there is water escaping the cabinet or the machine will not complete a normal wash.

Manual and support

Enter WFW5720RU into Whirlpool US Manuals & Literature and compare any returned file with the complete rating-label version before using it. This is a manual search page, not a direct PDF; a matching US manual and revision were not verified during this check.

If no matching document is available, contact Whirlpool with the model, any appended revision, and a photo of the message. No exact-model reset sequence has been verified, so none is supplied here.

Sources and author

By Ahmad Raza. Last checked: 2026-10-15. No independent technical review or hands-on test is claimed.

Product identity and named features: official US listing. Code applicability and exact revision-specific repair instructions: not verified.

MORE FROM THE SAME BRAND & APPLIANCE

Related Whirlpool Front load washer models

Compare published guides for other Whirlpool Front load washer models. Check the complete model number and market before following instructions.

Browse matching models